LEARN HOW TO FIT THE PROJECT KIT BY SEARCING OUR CPR CHASSIS GUIDES

BRAND NEW Stub Axle pair with BRAND NEW bearings, BRAND NEW spacer washers, and BRAND NEW wheel nuts!

These are quality 17mm Stub Axles for Race Karts.

If you're looking for a quality correctly manufactured component for a project which will be compatible with all race go kart front wheels (including race go kart off-road conversion wheels like our WSORBG) then don't get caught with a 15mm or even worse 10mm stub setup that you can't buy parts for.  Make sure you get yourself a kit lke this with 17mm stubs so you can buy wheels and bearings anywhere!

The PROJECT SERIES range of CPR products includes Brackets which weld to your frame to accept these spindles.  Your complete kit comes with two spindle brackets which can be welded to your project or existing kart frame to update/upgrade to CPR spindles.

These are less than half the price of other Go Kart Stores!

Designed as a direct replacement to fit ARROW, CRG, AND MANY OTHER KART DESIGNS where bearings are fitted to stub axles rather than the frame.

Colour: Silver

TYPE: Bearings contained in stub axle

INCLUDES

- KING PIN BOLTS
INCLUDES SPACER WASHERS (One set of 8 - 4x10mm & 4x5mm spacer washers - Colour as per title & title picture - NOTE: You may require additional spacers depending on the distance between the outer faces of your rims or hubs)
- WHEEL NUTS
- BEARINGS

- BRACKETS (Compatible with our CMBC01 camber adjustmernt kit included with this bundle)

- 14mm-8mm CAMBER/CASTOR Adjusters

- Enough washers to space stub axles.

COMPLETE BOLT-ON KIT, WELD and GO!

KING PIN Diameter: 8mm

To suit Wheel bearing Diameter: 17mm

Dimension A: 100mm
Dimension B: 18mm

Dimension A+B: 118mm

Dimension C: 22mm
Dimension D: 98mm (Shaft Length) - Use this length to determine the amount of spacers required in total to fit your wheels

Dimension E: 52mm
Dimension F: 2mm

Dimension C+D+E+F: 172mm

(For dimensions see last picture in set)

With the angles below, the first angle is as per the picture orientation (this is actually upside down).  The second angle is with the stub flipped and would be the angle when you've installed the stub right-side up.  Generally, use the second angle to measure on your kart if checking compatiblity. 

Angle X (angle between kingpin and stub shaft) ~65degrees / ~115degrees

Angle Y (angle between stub shaft, and line between kingpin and arm outer tie rod end hole) ~65degrees / ~115degrees

Angle between king pin and arm (not shown, as per picture orientation - stub is actually upside down)  - 85 degrees / 95 degrees

New.